new year new car gta v6 gt

A place to showcase your pride and joy

Moderators: eastlmark, BIG_MVS, Test Moderator

User avatar
User

JohnC

Rank

Non Member

Posts

2120

Joined

Sun Dec 02, 2007 6:19 pm

Location

Jersey C.I.


Has thanked: 15 times
Been thanked: 83 times

Re: new year new car gta v6 gt

Postby JohnC » Mon Apr 23, 2018 9:36 pm

As Custard and Darren have said ...... filp up the cap at the bottom of the arm to reveal the nut, remove and reset arm on the spline to the park position as shown below.

Wipers.jpg
You do not have the required permissions to view the files attached to this post.
1990 GTA Atmo, 2003 Jaguar X type 2.5SE Auto, 2018 Kia Picanto GT-Line-S 1.25
User avatar
User

mettersl

Rank

Club Member

Club Member
Posts

2027

Joined

Sat Nov 13, 2004 12:46 pm

Location

Saffron Walden- North Essex


Has thanked: 23 times
Been thanked: 59 times

Re: new year new car gta v6 gt

Postby mettersl » Mon Apr 23, 2018 11:31 pm

I should have made it clear, the wiper is properly attached to the splines, it’s just not rotating the correct amount..... moving it down means there is an unswept area in the middle...that would be an mot issue.
Very odd.
Does anyone have one out of a car they can take a picture of? I had two but needed to make one good one as I had one stuck spindle in each. The workshop manual helpfully tells you to get it right, but doesn't provide enough detail to do so...
Last edited by mettersl on Tue Apr 24, 2018 6:46 am, edited 1 time in total.
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Re: new year new car gta v6 gt

Postby clee » Tue Apr 24, 2018 6:08 am

The linkage arm positions are critical.
I don't have a picture but will see if I have a mech out a car I can photograph.
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Re: new year new car gta v6 gt

Postby clee » Tue Apr 24, 2018 6:55 am

Roughly from a while back ....It should be somewhere near, you may just need to position the linkage to the motor slightly further round so it lines up but is all relative. Looks like that link is not dead center but you can see it.

WP_20150617_003.jpg
You do not have the required permissions to view the files attached to this post.
no avatar
User

Dave Williams

Rank

Non Member

Posts

634

Joined

Mon Apr 19, 2004 8:43 pm

Location

Surrey


Has thanked: 15 times
Been thanked: 35 times

Re: new year new car gta v6 gt

Postby Dave Williams » Tue Apr 24, 2018 7:41 am

One for sale on eBay..the photo might help (ex Cedric I think)..though without motor in place may not be so useful.
I know I did mine way back...trial and error.
If you are time poor maybe make them an offer..
(And sell on yours when aligned)Image

Sent from my MotoG3 using Tapatalk
User avatar
User

mettersl

Rank

Club Member

Club Member
Posts

2027

Joined

Sat Nov 13, 2004 12:46 pm

Location

Saffron Walden- North Essex


Has thanked: 23 times
Been thanked: 59 times

Re: new year new car gta v6 gt

Postby mettersl » Tue Apr 24, 2018 7:59 am

Thanks Gents,
There are two adjustment points...one is the motor angle when parked the other is the intermediate crank position - unfortunately neither picture has the motor mounted.
I've got the RHS working fine (by trial and error), what I hadn't appreciated is the other adjustment seems to impact the stroke of the LHS wiper.
As I think its fine for the MOT, I think I'll leave this for now and add this to the "post macon" list.
BUT if anyone has a picture of a RHD mechanism with the motor mounted and at the park position, that would be great.
Cheers
Lee
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Re: new year new car gta v6 gt

Postby clee » Tue Apr 24, 2018 8:26 am

Booommmmm!!!
WP_20180424_002.jpg

WP_20180424_003.jpg
You do not have the required permissions to view the files attached to this post.
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Re: new year new car gta v6 gt

Postby clee » Tue Apr 24, 2018 8:28 am

Not the UK's biggest and best for nothing you know.......
User avatar
User

mettersl

Rank

Club Member

Club Member
Posts

2027

Joined

Sat Nov 13, 2004 12:46 pm

Location

Saffron Walden- North Essex


Has thanked: 23 times
Been thanked: 59 times

Re: new year new car gta v6 gt

Postby mettersl » Tue Apr 24, 2018 3:31 pm

thanks...
Lee
User avatar
User

mettersl

Rank

Club Member

Club Member
Posts

2027

Joined

Sat Nov 13, 2004 12:46 pm

Location

Saffron Walden- North Essex


Has thanked: 23 times
Been thanked: 59 times

Re: new year new car gta v6 gt

Postby mettersl » Fri Apr 27, 2018 10:24 pm

Wipers need to come out for more adjustment...but I’ll leave that for now...it’s ok for mot.
Door lock...turned out to be overlength bolts cutting into the insulation and creating a short in the locks...shorter bolts now and I have normal locking and even a working plipper...
Phew...this took me ages..,thanks for the help from everyone I asked about this...helped me get there in the end.
Mot tomorrow....fingers crossed...even if it looks like new underneath and on top,...
no avatar
User

Custard

Rank

Non Member

Posts

790

Joined

Sat Oct 12, 2013 7:02 pm


Has thanked: 1 time
Been thanked: 35 times

Re: new year new car gta v6 gt

Postby Custard » Sat Apr 28, 2018 6:23 am

Fingers crossed for the mot, l would not worry about the wipers because at the moment the long range forecast is showing no rain for the hole event might even see some sun, but probably high level clouds down there as there is so much snow in the mountains all evaporateing.
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Re: new year new car gta v6 gt

Postby clee » Sat Apr 28, 2018 7:03 am

Can I have my long stainless bolts back then please :D What are the chances?
no avatar
User

Custard

Rank

Non Member

Posts

790

Joined

Sat Oct 12, 2013 7:02 pm


Has thanked: 1 time
Been thanked: 35 times

Re: new year new car gta v6 gt

Postby Custard » Sat Apr 28, 2018 7:38 am

You must no my mate Mr tight is tight or what LOL
User avatar
User

mettersl

Rank

Club Member

Club Member
Posts

2027

Joined

Sat Nov 13, 2004 12:46 pm

Location

Saffron Walden- North Essex


Has thanked: 23 times
Been thanked: 59 times

Re: new year new car gta v6 gt

Postby mettersl » Sat Apr 28, 2018 8:04 am

Sorry Lee, your long bolts have been cut down to size.....sorry....
Surprising levels of low end torque on these atmo's, at least as far as you can tell on a wet morning trip to the MOT...
mixture/idle need some work, and a few other niggles will need attention this wee BUT IT passed.......fog light bulb needed changing (not sure how I missed that).

Now onto next stuff
Leaky rear light units (that can wait)
tracking...definitely needs doing...as expected.
Petrol gauge decrements but always starts at 6.2 gallon (Stuck float maybe?)
Speedo is either accurate or not there...(Assume that's the usual connector).- seems to be sorting itself out for now
Aside of that all seems to be working...and its LEGAL(and no advisories either) !!
Last edited by mettersl on Sat Apr 28, 2018 4:54 pm, edited 1 time in total.
User avatar
User

darrenbiggs

Rank

Non Member

Posts

1499

Joined

Thu Apr 29, 2004 1:03 pm

Location

Horley - Nr Gatwick


Has thanked: 15 times
Been thanked: 39 times

Re: new year new car gta v6 gt

Postby darrenbiggs » Sat Apr 28, 2018 10:31 am

Very well done Lee. I need to MOT mine, even finding the time is a hassle at the moment. Two new tyres to go on the front too with new metal valve stems... hopefully cure the mystery slow puncture.
I'm just here for the gasoline.
PreviousNext


  • Advertisement

Who is online

Users browsing this forum: Google [Bot] and 18 guests

Powered by phpBB ® | Renault' and 'Alpine' are trademarks of Renault S.A.S. or its subsidiaries and are used with kind permission of Renault France